Serving our customers with quality and safety first.
+0.9487/+0.9521in.
RIGHT-Hand
1.250in. nut and 1.255in. nut
0.290in. and 0.320in.
sleeve
1.180in. and 1.200in.
0.340in. and 0.360in. ⁓3/8"
0.190in. nut and 0.215in. nut
1.490in. and 1.510in.
hexagonal flange
round nut
un
32
28.0 rockwell c and 34.0 rockwell c
1.000in. ⁓1/64"
6 locking slots on flange periphery equally spaced 0.130 in. max wide 0.215 in. max deep
steel comp 4130 or steel comp 4340
MIL-S-6758 mil spec 1st material response or MIL-S-5626 mil spec 1st material response or MIL-S-5000 mil spec 2nd material response
1EA
Steel comp 4130 or steel comp 4340
32
Right-hand
Schedule B number: 7318160000
nmfc 194160
Nuts of iron or steel
FSC 5310 ⁓ Nuts and washers
Note-nuts and washers, including specially designed, are to be classified in this fsc. a. nuts are a small metal block made in a variety of shapes such as square and hexagonal which is drilled and internally threaded. b. washers are a perforated piece of metal, leather, or other materials of various shapes or forms. they are used primarily as a seat for a bolt, nut, screw, rivet or nail to distribute pressure and prevent endwise motion over an area and/or to prevent movement between two parts by means of restraining features created by the shape of its edges.
Excluding bearing thrust washers (fsc 3120); shims (fsc 5365); ring spacers (fsc 5365); plate spacers (fsc 5365); lock rings (fsc 5365).
6 locking slots on flange periphery equally spaced 0.130 in. max wide 0.215 in. max deep 32 thread quantity per inch right-hand
Nothing similar to this part number was found in our inventory
An internally threaded item with a cylindrical and/or square, hexagonal, octagonal, or dodecagonal outer periphery (parallel to the threaded axis) a portion(s) of which may or may not be enlarged, forming a flange(s) and/or shoulder(s). items not having an enlarged outer portion may be threaded, a part of the full length, or tapped from both ends. items having an enlarged outer portion (flange(s) or shoulder(s)) may be threaded the full length, threaded a part of the full length, or tapped from both ends. items tapped from both ends shall have either right-hand threads on both ends or left-hand threads on both ends. for items conforming to any of the above and having a length overall exceeding two times the largest outside diameter or width across flats, use post, electrical-mechanical equipment. for items with an outside contour that is the same the full length, having a continuous thread through its entire length, and the length does not exceed two times the diameter or width across the flats use nut (1), plain (as modified). excludes nut (1), plain, cap. see also turnbuckle body.