Serving our customers with quality and safety first.
1.200in. and 1.250in. ⁓1-1/4"
1.482in. and 1.483in.
1.732in. and 1.735in.
0.150in. and 0.170in.
0.060in. and 0.070in.
63.0 microinches outer
steel corrosion resisting
B50T13c, fscm 07482 mfr ref single material response
shouldered
81343-AMS2640 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.) .
Shouldered
Steel corrosion resisting
0.060 inches minimum and 0.070 inches maximum
1.732 inches minimum and 1.735 inches maximum
1.200 inches minimum and 1.250 inches maximum
Schedule B number: 7318220000
nmfc 194160
Washers other than lock washers, iron or steel
FSC 5310 ⁓ Nuts and washers
Note-nuts and washers, including specially designed, are to be classified in this fsc. a. nuts are a small metal block made in a variety of shapes such as square and hexagonal which is drilled and internally threaded. b. washers are a perforated piece of metal, leather, or other materials of various shapes or forms. they are used primarily as a seat for a bolt, nut, screw, rivet or nail to distribute pressure and prevent endwise motion over an area and/or to prevent movement between two parts by means of restraining features created by the shape of its edges.
Excluding bearing thrust washers (fsc 3120); shims (fsc 5365); ring spacers (fsc 5365); plate spacers (fsc 5365); lock rings (fsc 5365).
shouldered 0.060" material thickness 1.732" outside diameter 1.200" hole diameter
Nothing similar to this part number was found in our inventory
A washer, round in shape, and having a centrally located hole. one bearing surface is flat and unbroken, the other surface is in the form of a raised shoulder (boss) having a flat bearing surface. the thickness of the shoulder (boss) must not exceed 25 percent of the shoulder (boss) diameter. for items having a shoulder (boss) of greater thickness, use bearing, sleeve; bushing sleeve; or spacer, sleeve. excludes insulator, washer and thrust type washers.