Serving our customers with quality and safety first.
rectangular
2.7 mm
round
1 round
0.5 mm
6.5 mm
steel comp 301 and steel comp 302 and steel comp 303 and steel comp 303se and steel comp 304 and steel comp 304l and steel comp 305 and steel comp 308 and steel comp 309 and steel comp 309s and steel comp 310 and steel comp 310s and steel comp 314 and steel comp 316 and steel comp 316l and steel comp 317 and steel comp 321 and steel comp 347 and steel comp 348 and steel comp 384 and steel comp 385
passivate
QQ-P-35 fed spec single treatment response
Steel comp 301 and steel comp 302 and steel comp 303 and steel comp 303se and steel comp 304 and steel comp 304l and steel comp 305 and steel comp 308 and steel comp 309 and steel comp 309s and steel comp 310 and steel comp 310s and steel comp 314 and steel comp 316 and steel comp 316l and steel comp 317 and steel comp 321 and steel comp 347 and steel comp 348 and steel comp 384 and steel comp 385
2.7 millimeters
Schedule B number: 7318220000
nmfc 194160
Washers other than lock washers, iron or steel
FSC 5310 ⁓ Nuts and washers
Note-nuts and washers, including specially designed, are to be classified in this fsc. a. nuts are a small metal block made in a variety of shapes such as square and hexagonal which is drilled and internally threaded. b. washers are a perforated piece of metal, leather, or other materials of various shapes or forms. they are used primarily as a seat for a bolt, nut, screw, rivet or nail to distribute pressure and prevent endwise motion over an area and/or to prevent movement between two parts by means of restraining features created by the shape of its edges.
Excluding bearing thrust washers (fsc 3120); shims (fsc 5365); ring spacers (fsc 5365); plate spacers (fsc 5365); lock rings (fsc 5365).
passivate surface treated 2.7mm hole diameter
1. | A3013124-3 | Cage 51792 |
2. | A3013124-3 | Cage 80063 |
3. | 517702-3 | Cage 31550 |
Nothing similar to this part number was found in our inventory
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.