Serving our customers with quality and safety first.
rectangular
0.318in. and 0.338in. ⁓11/32"
round
1 round
0.013in. and 0.019in. ⁓1/32"
0.557in. and 0.582in. ⁓19/32"
aluminum alloy 2024
QQ-A-250/5 fed spec single material response
oxide film or anodize
MIL-C-5541 mil spec 1st treatment response or MIL-A-8625 mil spec 2nd treatment response
1HD
Aluminum alloy 2024
0.318 inches minimum and 0.338 inches maximum
Schedule B number: 7616108000
nmfc 194120
Cotters, cotter-pins, washers and similar articles, of aluminum
FSC 5310 ⁓ Nuts and washers
Note-nuts and washers, including specially designed, are to be classified in this fsc. a. nuts are a small metal block made in a variety of shapes such as square and hexagonal which is drilled and internally threaded. b. washers are a perforated piece of metal, leather, or other materials of various shapes or forms. they are used primarily as a seat for a bolt, nut, screw, rivet or nail to distribute pressure and prevent endwise motion over an area and/or to prevent movement between two parts by means of restraining features created by the shape of its edges.
Excluding bearing thrust washers (fsc 3120); shims (fsc 5365); ring spacers (fsc 5365); plate spacers (fsc 5365); lock rings (fsc 5365).
oxide film or anodize surface treated 0.318" hole diameter
1. | AN960D516L | Cage D9182 |
2. | NAS1197-516L | Cage D9182 |
3. | FF-W-92 | Cage 81348 |
4. | 4197410-030 | Cage 05869 |
5. | 8137492 | Cage 18876 |
6. | 4197410-030 | Cage 82577 |
7. | NAS1149D0516J | Cage 80205 |
8. | AN960PD516L | Cage 0P012 |
9. | AN960PD516L | Cage 88044 |
10. | 10088001 | Cage A486G |
Nothing similar to this part number was found in our inventory
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.