Serving our customers with quality and safety first.
rectangular
0.264in. ⁓17/64"
round
1 round
0.038in. and 0.040in. ⁓3/64"
0.366in. ⁓3/8"
6000 pounds per square inch
cellulose
MIL-G-12803, no. 3200-a mil spec single material response
Cellulose
0.264 inches
Schedule B number: 3926904500
nmfc 194120
Gaskets,washers & other seals
FSC 5310 ⁓ Nuts and washers
Note-nuts and washers, including specially designed, are to be classified in this fsc. a. nuts are a small metal block made in a variety of shapes such as square and hexagonal which is drilled and internally threaded. b. washers are a perforated piece of metal, leather, or other materials of various shapes or forms. they are used primarily as a seat for a bolt, nut, screw, rivet or nail to distribute pressure and prevent endwise motion over an area and/or to prevent movement between two parts by means of restraining features created by the shape of its edges.
Excluding bearing thrust washers (fsc 3120); shims (fsc 5365); ring spacers (fsc 5365); plate spacers (fsc 5365); lock rings (fsc 5365).
0.264" hole diameter
1. | 6080 | Cage 78640 |
2. | T56-52 | Cage 79960 |
3. | 850842 | Cage 77237 |
4. | T56-52 | Cage 77237 |
5. | 53792D | Cage 29930 |
6. | T56-52 | Cage 06840 |
7. | JHP33-241 | Cage 02032 |
8. | 850842 | Cage 12603 |
9. | T56-52 | Cage 12603 |
10. | T56-52 | Cage 76126 |
11. | 925505 | Cage 12204 |
12. | CP450-9 | Cage 82272 |
13. | 53792D | Cage 31007 |
Nothing similar to this part number was found in our inventory
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.