Serving our customers with quality and safety first.
rectangular
0.250in. and 0.256in. ⁓17/64"
rectangular
1 round
0.032in. ⁓3/64"
0.510in. and 0.570in.
an/APN-169B
0.310in. and 0.370in. ⁓3/8"
washer, switch KEYING-Slotted at one end, width of slot .067 pom .003, hole center to the end of slot radius .250, length of key .023 plus .005 or minus .002, width of key .030 to .035, center of hole from slotted end .340
copper alloy 268
QQ-B-613, comp 1 fed spec single material response
nickel
Copper alloy 268
0.250 inches minimum and 0.256 inches maximum
Schedule B number: 7415210000
nmfc 194160
Copper washers including spring washers not threaded
FSC 5310 ⁓ Nuts and washers
Note-nuts and washers, including specially designed, are to be classified in this fsc. a. nuts are a small metal block made in a variety of shapes such as square and hexagonal which is drilled and internally threaded. b. washers are a perforated piece of metal, leather, or other materials of various shapes or forms. they are used primarily as a seat for a bolt, nut, screw, rivet or nail to distribute pressure and prevent endwise motion over an area and/or to prevent movement between two parts by means of restraining features created by the shape of its edges.
Excluding bearing thrust washers (fsc 3120); shims (fsc 5365); ring spacers (fsc 5365); plate spacers (fsc 5365); lock rings (fsc 5365).
Used on an/apn-169b. nickel surface treated washer, switch keying-slotted at one end, width of slot .067 pom .003, hole center to the end of slot radius .250, length of key .023 plus .005 or minus .002, width of key .030 to .035, center of hole from slotted end .340 0.250" hole diameter
Nothing similar to this part number was found in our inventory
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.