Serving our customers with quality and safety first.
rectangular
0.262in. and 0.268in. ⁓9/32"
round
1 round
0.040in. and 0.044in. ⁓3/64"
0.747in. and 0.753in. ⁓49/64"
steel comp 301 or steel comp 302 or steel comp 303se or steel comp 304 or steel comp 304l or steel comp 305 or steel comp 308 or steel comp 309 or steel comp 309s or steel comp 310 or steel comp 310s or steel comp 314 or steel comp 316 or steel comp 316l or steel comp 317 or steel comp 321 or steel comp 347 or steel comp 348 or steel comp 385
QQ-S-763 fed spec all material responses
passivate
QQ-P-35 fed spec single treatment response
1EA
Steel comp 301 or steel comp 302 or steel comp 303se or steel comp 304 or steel comp 304l or steel comp 305 or steel comp 308 or steel comp 309 or steel comp 309s or steel comp 310 or steel comp 310s or steel comp 314 or steel comp 316 or steel comp 316l or steel comp 317 or steel comp 321 or steel comp 347 or steel comp 348 or steel comp 385
0.262 inches minimum and 0.268 inches maximum
Schedule B number: 7318220000
nmfc 194120
Washers other than lock washers, iron or steel
FSC 5310 ⁓ Nuts and washers
Note-nuts and washers, including specially designed, are to be classified in this fsc. a. nuts are a small metal block made in a variety of shapes such as square and hexagonal which is drilled and internally threaded. b. washers are a perforated piece of metal, leather, or other materials of various shapes or forms. they are used primarily as a seat for a bolt, nut, screw, rivet or nail to distribute pressure and prevent endwise motion over an area and/or to prevent movement between two parts by means of restraining features created by the shape of its edges.
Excluding bearing thrust washers (fsc 3120); shims (fsc 5365); ring spacers (fsc 5365); plate spacers (fsc 5365); lock rings (fsc 5365).
passivate surface treated 0.262" hole diameter
Nothing similar to this part number was found in our inventory
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. the hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). the thickness cannot exceed 25 percent of the largest outside dimension. when the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. the maximum tolerance is applied to dimensions and used as a determining factor. items with separable lamination use shim. for items fabricated from ceramic or electrically rated materials by specification or industry standards use insulator (1), washer. excludes disk, valve, graphite impregnated and lubricated items.