Price Quote Get an up to date pricing and availability quote for this product. Order online or over the phone.
Quality Commitment
Serving our customers with quality and safety first.
- AS9120 Certified
- Audited supply chain
- ITAR Registered
- DDTC Registered
- HAZMAT Certified
- Customer service objectives
- Every product 100% inspected
Datasheet. 21535222 specification
End Item Identification
The national stock number or the identification information of the end equipment for which the item is a part.
The national stock number or the identification information of the end equipment for which the item is a part.
alco 251 diesel engine
Special Features
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.
Those unusual or unique characteristics or qualities of an item not covered in the other requirements and which are determined to be essential for identification.
stud, bearing frame to seal plate 3/8-16 x 1-1/2
Answers.
What's the federal classification of 21535222?
FSC 5307 ⁓ Studs
NSN 5307-01-470-5785 STUD,PLAIN
Used on alco 251 diesel engine. stud, bearing frame to seal plate 3/8-16 x 1-1/2
- NIIN
- 014705785
- NIIN Date
- 12/27/99
- Schedule B
- Name Code
- 15948
- FIIG
- A051A0
- DEMIL / ITAR
- Uncontrolled item (Code A)
- Hazmat
- No hazard information available from HMIRS.
- MSDS
- N/A
- Precious Metals
- No precious metals
- Enviromental
- N/A
- Electrostatic ESD & EMI
- No ESD or EMI sensitivity
Major End Users Countries and entities
- - Australia
Availability for 21535222 A member of our team will provide you with a price and availability quote
Request a Quote »Similar by Design Other studs with similar characteristics
Nothing similar to this part number was found in our inventory
21535222 / Stud,plainWhat is the formal definition of this item?
A headless fastener not exceeding 12 inches (304.8 mm) in length, threaded externally on both ends with threads of the same nominal diameter. the maximum diameter of the unthreaded portion must not be greater than the nominal thread diameter plus 0.020 inches (0.508 mm). the unthreaded portion must be without locking or wrenching provisions. it may be thread relieved. see also rod, threaded end and rod, continuous thread.
