Recently Updated NSNs

diameter 1.62 plastic material

height 0.695 vibration resistance range in hertz +10 to 2000 operating temp range -20 to 71 degrees celsius

maximum operating pressure 26 pounds per square inch gage voltage standing wave ratio 1.2 aluminum material waveguide outside width 3

body length 1.969 minimum and 2.031 maximum nominal thread size 0.138 operating voltage type and rating per pole in volts 240 ac single location maximum continuous load current rating per pole 3 amperes ac single location

temp coefficient of resistance in ppm per degrees celsius -100 to 100 body length 0.625 electrical resistance 21.5 kilohms unpackaged unit weight 0.84 grams

length 1.344 mounting hole diameter 0.125 width 0.438 contact maximum current rating in amps 3

length 5.016 operating temp range -65/+125 degrees celsius height 3.031 contact voltage rating in volts 120 ac at sea level

height 2.906 center to center distance between mounting facilities parallel to height 2.375 width 2 distance between centerlines of mounting facilities parallel to body width 0.874

temp coefficient of resistance in ppm per degrees celsius -50 to 50 body length 0.25 ambient temp in degrees celsius at full rated power 125 body diameter 0.109

plate bearing nsn 3110000082413.

length 1.081 minimum and 1.082 maximum steel material

core coil nsn 5950000082409.

end overall length 5

cable coaxile type no.rg179bu contact outer contact ferrule connector contact outer radar set jetds type no. an/fps27a

width 3.375 extended length 33.75 aluminum material

bracket assembly nsn 5815000082383.

aircraft use aluminum alloy 15.2 in. length 15.2 in. width 0.064 in. thickness

length 63 height 55 width 21 weight 700 pounds

width 18 height 5.25 length 19 input impedance rating 50 ohms

length 19 height 3.5 width 16 output impedance rating 600 ohms

length 1.54 height 2.47 plastic material width 2.47

fastener length 3.2 minimum and 3.22 maximum nominal thread diameter 0.086 thread length 1.75 minimum aluminum screw material

height 0.125 cotton and rubber material

length 0.785 width 0.785 aluminum material

diameter 0.31 minimum and 0.314 maximum pin chamfer angle 45 degrees steel material height 0.07 minimum and 0.09 maximum

height 0.25 material hardness rating 90 durometer

gearbox piston rod nsn 1680000082308.

c/o adapters hoses holding fixtures cables and special accessories used to adapt the subsystem components to the test station test package name-vertical speed indicator test package

used to adapt the subsystem components to the test station test package name-iff control panel test package

used to adapt subsystem componets to the test station test package name-engaging controller test package