Used on next higher assembly drawing 4391b1600. footswitch assembly cage notes 3, 12; type pm part mark per BAC5307, code ra. all characters .125 inch high . locate approximately as shown on drawing picture sheet. note 12 type fn touch up all internal bare areas with f-20.02 followed by f-22.06-26373
illuminated pushbutton switch several pushbutton styles available from standard with .53 square legend area to the largest with .64 x.84 legend area.switching actions maintained depressed alternate action. pushbutton stays in the down position giving a visual indication of what mode switch is in when not illuminated. when pushed again the pushbutton returns to the up position.momentary, magnetic holding
wirewound resistors, commercial coated, axial lead rohs compliant; lead (pb) free; standard terminals are tinned copperweld, end caps are stainless steel; coefficient temp +-30ppm/degrees celsius axial terminal each end
single axis joystick-series 829 hall effect sensor; handle type f; rubber boot; center detect switch:switch type: spdt (N0-c-nc) , electrical rating: 30vdc/100ma; operational life: 100, 000; activation: on at center off at plus or minus zero from center handle operating angle plus or minus 20 -25 from center position (40 -50 ) operating force approx. 1n (with standard spring return incorporated) ; max. applied voltage 10 vdc
series c miniature switch part number no. of poles:3; no. of positions:4; indexing angle:30; operation shorting; shaft: stainless steel; housing:zinc; shaft
